Sanitizer ASC-1®
The ASC-1 Sanitizer Series is the only multi-purpose water treatment system that effectively removes hardness, iron and manganese; raises pH; and disinfects itself automatically during regeneration.

Media: Crystal-Right CR-100

 Sanitizer Units

Literature pdf

ASC-1 Overview
Capacity Specifications for the ASC-1 Sanitizer Series
MODEL ASC1-1044 ASC1-1054 ASC1-1354
(1)Capacity:
Grains/Lbs. NaCl		 Maximum 11,800 @ 12.4 22,600 @ 15.9 36,900 @ 21.2
Medium 11,400 @ 9.3 20,700 @ 12.4 33,600 @ 15.9
Minimum 7,300 @ 3.2 16,400 @ 6.1 28,300 @ 9.5
Amount of Media (Cu. Ft.)

1.0

 1.5 2.5
Maximum Water Hardness (GPG) 20 30 40
(2)Maximum Iron (PPM) 8 10 15
(3)Minimum pH Required 6.5 6 6
(4)Total pH Adjusted Water at Continuous Flows 630 252 432
(5)Peak Flow Rate (GPM @ P-PSI) 19 @ 15 17@15 19 @ 15
Continuous Flow Rate (GPM @ P-PSI) 9 @ 5psi 8 @ 5 9 @ 5
Water Pressure Range (PSI) 25 - 100 25 - 100 25 - 100
Water Temperature (oF) 33 - 100 33 - 100 33 - 100
Electrical Requirements (volts-hertz) 110 - 50/60 110 - 50/60 110 - 50/60
Pipe Size 1" 1" 1"
Tank Size Media Tank 10"(w) x 52 "(h) 10"(w) x 62 "(h) 13"(w) x 62 "(h)
Brine Tank 18"(w) x 33"(h) 18"(w) x 33"(h) 18"(w) x 40"(h)
1 All Water-Right Water Conditioners are pre-factory set at medium salting. Note: influent waters must be at least 3 GPG. A calcite or corsex unit may be needed for correct operation.
2 Iron removal may vary depending on form of iron, pH and other local conditions. On waters that are pre-chlorinated or where other pre-oxidation occurs, an iron precipitate can form that is too small to be filtered.
3 The pH listed is the minimum for the influent water.
4 This is the minimum number of gallons at the continuous flow rate corrected to a 7 pH. The actual amount of pH adjusted water may be greater.
5 Unit not tested for capacity at these flow rates. Water quality may vary.

1900 Prospect Court • Appleton, WI • Phone: (920) 739-9401 • Fax: (920) 739-9406
©2004 Water-Right, Inc.